Emu#dreams Forum | Download | RSS | IRC | ADD NEWS | last 7 days | last 31 days | MUSEUM

WinUAE 4.0.1 Final [300][witek], 2018-07-17 11:14:50

[Source: http://www.winuae.net]

4.0.0 bugs fixed:

-Enabled Minimize when focus is lost option caused crash in some situations.
-64-bit FPU mode always changed back to 80-bit if config file was loaded.
-80-bit native FPU mode FREM and FMOD returned wrong results.
-RTG statefile restore did not restore screen state completely.

Other bugs fixed:

- Minimize when focus is lost incorrectly activated when switching modes in some situations.
- Minimize when focus is lost minimized main emulation window when GUI was open and main window lost focus.
-If CPU panel FPU mode select menu was active and then some other panel was opened: JIT was switched off.
-CD audio play from real/virtual CD (not from directly mounted image file) did not restart correctly if audio settings changed.
-Only some emulated SCSI controllers flashed CD led when emulating a CD drive.
-input.keyboard_type was always read as Amiga keyboard. If PC layout was set as default, keyboard layout was read incorrectly from config file.
-Amiga reset during active RTG rendering in RTG Multithread mode could have caused a crash.
-RTG Multithread mode display refreshing was unreliable in 8-bit modes when palette changed.
-Finally fixed corrupted drag and drop graphics in Harddrives and Disk Swapper panel.
-When inserting previously connected USB input device, previous device type (Gamepad, CD32 pad etc) and autofire mode (if any) was not restored.
-Clipboard sharing could have attempted to transfer data to Amiga side after program had taken over the system, possibly overwriting memory.

New features:

-Environmental variables (%variable%) in paths are not anymore resolved immediately when config is loaded but only when needed without modifying original path, preserving original path if config file is saved again.
-Added full statefile absolute/relative path support. Loading statefile will restore correct paths even if absolute/relative path mode was changed after saving the statefile.
-D3D9 and D3D11 VSync mode (both lagless and standard) 100/120Hz support with optional black frame insertion.
-68060 FPU was not disabled after soft reset if 68060 was configured without emulated 68060 accelerator board, causing reset loop.

New emulated expansions:

-QuikPak 4060

W paczce 32/64bit intaller,gotowiec,pluginy.


COMMENTS:




Only for registered users!
[LOG IN | REGISTER]